Engine diagnostics & repair
Check engine light diagnostics and engine repair in Beavercreek, OH
We diagnose check engine lights and drivability problems with factory-level diagnostic software, not a generic code reader. You get written findings that say what failed, what it costs to fix and what can wait. Nothing is repaired until you approve the estimate.
Price Quoted up frontWhat is included
- Check-engine light diagnosis with factory diagnostic software
- Timing chain and belt service, VANOS and tensioner repair
- Spark plugs, fuel system service and injector cleaning
- Transmission service and fluid exchange (DSG, 7G/9G-Tronic, ZF)
- Clutch, CV axle and driveshaft repair
- Written findings before any repair is approved
Common reasons people bring the car in
- Check engine light is on or flashing
- Rough idle, misfire or hesitation
- Oil or coolant on the ground
- Rattle on a cold start
- Loss of power or the car going into limp mode
How it works here
A code tells you which system reported a fault. It does not tell you which part failed. We read the stored data, test the parts involved and confirm the cause before recommending a repair. If a test shows the first guess was wrong, you do not pay for a part you did not need.
Is it safe to drive with the check engine light on?
A steady light usually means the car can be driven to the shop, though you should book soon. A flashing light means an active misfire that can damage the catalytic converter. In that case stop driving and call us about towing at (937) 609-7536.
How is your diagnostic different from a free code scan at a parts store?
A parts-store scanner reads generic emissions codes. Factory-level software reads every module in the car, shows live data and runs the manufacturer test plans. That is usually the difference between replacing the right part once and replacing three parts to find the problem.
Do I get an estimate before any repair?
Yes. You get a line-item estimate with parts, labor and the reason for each item. We start only after you approve it.
Call and you get the shop.
The person who answers is the person who will work on your car. You get a line-item estimate and approve it before anything starts. If the car can't be driven, we'll tow it.